Installation Guide

Luxier SP06-CEC Rev. A 1020199

Installation (cont.)

8. Measure the length needed for the main water

supply hoses. Trim o󰀨 the excess PVC tubing.

9. After the excess hose has been trimmed. First slip

hose clamp (B) onto the PVC hose (C). Insert the

elbow connector (A) into the hose. Push the hose

(B) up toward the end of the hose. Tighten the hose

clamp (B)

(NOTE: Do not over tighten the clamp)

10. Wipe the surrounding surface around the pipe free

of dirt and debris. Peel o󰀨 the adhesive backing of the

cover base (A) and press it rmly against the wall to

ensure a tight bond. Apply some PTFE tape on the

pipe threading. Connect the main water supply hose

assembly to the pipe.

(NOTE: Do not over tighten the nut as it may damage

the seal and causes leaks) Once the connection is

made, install the cover over the elbow connector.

11. Connect hand shower hose to the main panel

body and connect the hand shower wand to the hose.

Make sure the silicon gaskets are seated properly

to prevent water leak. Run water to the unit for few

minutes and check for leaks at all connections.