Installation Guide

Luxier SP06-CEC Rev. A 1020198
1”
Installation (cont.)
4. Lift the panel to determine the proper height and
placement. It is recommened to aim the top horizon-
tal body jet to the chest area for optimal showering
experience. Mark the positions of the 2 brackets on
the wall and set a side the panel.
(NOTE: The distance between the two brackets
should be 444 mm or 17.48”)
444 mm
17.48 ”
5. Using a drill with a tile bit, drill the hole slowly into
the tile. Do not drill into any piping or wiring in the
wall. Insert the anchors into the wall.
(NOTE: Before drilling the tiles, use a small piece of
painters tape or masking tape over the drill area. This
will prevent damages to the tiles)
6. Secure the mounting brackets to the wall.
7. Hang the unit on the wall to complete the
installation. Due to the limited space behind the
shower panel, do not bend the hoses. Any restrictions
in the water supply hoses will greatly reduce the
performance of the shower panel.