Installation Guide

7Luxier

SP04-SS-TB Rev. B 022018

Installation

1. Install hand shower cradle (1) to the shower panel by

installing the rubber washer (2) and the locking nut (3) and

attach white plastic hose tube connector (5) with PVC tubing

to complete the connection. (NOTE: Make sure the silicon

gasket (4) is seated properly inside the connector.)

2. Connect the tub spout (1) to the shower panel with

the rubber washer (2) and the locking nut (3) and attach

plastic hose connector (5) with PVC tubing to complete the

connection. (NOTE: Make sure the silicon gasket (4) is seated

properly inside the connector.)

3. Connect hand shower hose to the main panel body and

connect the hand shower wand to the hose. Make sure the

silicon gaskets are seated properly to prevent water leak.

800mm

31.50”

4. Mark the positions of the 2 brackets on the wall and

prepare the tile wall for drilling. Use a piece of painters tape

or masking tape over the drill area to prevent damages to the

tiles.

(NOTE: The distance between the two brackets should be

800mm or 31.5”)