Installation Guide

Luxier SP04-SS-D Rev. D 0220189
Operation
1. Turn the temperature control knob to set the desired water
temperature. The control is preset to maximum temperature of
100.4 degrees Fahrenheit. To set higher water temperature,
push down the safety pin and turn the dial counterclockwise
to the desired temperature mark. (IMPORTANT: Scalding
may occur if bypass the safety pin, use this control with
caution)
2. Select the desired water function by turning the selector to
the corresponding marking. Multiple functions can be used
simultaneously only if there is adequate water pressure
supplied to the shower panel.
Water Functions
Overhead Jets
Overhead WaterfallHorizontal Body Jets
Handheld Shower
Temperature Control
Function Selectors
IMPORTANT:
The range of the control knob is limited in both clockwise and counter-clockwise directions.
DO NOT force to turn the knob pass its limit. Overturning the control will damage the
thermostatic valve making it fail to regulate temperature.
Maintenance Guide
Please follow the cleaning material manufacturer’s instructions. In addition, pay attention to the
following points:
1. Regular cleaning can prevent mineral build up on shower head and handheld shower.
2. Use a mild detergent such as liquid dishwashing soap and warm water for cleaning.
3. Do not use abrasive / harsh chemical when cleaning the  xture as they will damage and dull the
 nish.
4. Carefully read the cleaner product label to ensure the cleaner is safe for use on the material.
5. Test the cleaner on a small area before using on the entire surface.
6. Do not leave the cleaner on the  xture longer than necessary.
7. When using spray cleaners, spray  rst onto a soft cloth or sponge. Never spray directly onto the
faucet as droplets can enter openings and gaps and cause damage.
8. After cleaning, rinse thoroughly with clean water to remove any cleaner residue.
9. Wipe dry with soft cloth to keep shower panel surface spot free.