Installation Guide

Luxier SP04-SS-D Rev. D 0220187

Installation

760mm

29.92”

1. Install hand shower cradle (1) to the shower panel by

installing the rubber washer (2) and the locking nut (3) and

attach white plastic hose tube connector (5) with PVC tubing

to complete the connection. (NOTE: Make sure the silicon

gasket (4) is seated properly inside the connector.)

2. Connect hand shower hose to the main panel body and

connect the hand shower wand to the hose. Make sure the

silicon gaskets are seated properly to prevent water leak.

3. Mark the positions of the 2 brackets on the wall and

prepare the tile wall for drilling. Use a piece of painters tape

or masking tape over the drill area to prevent damages to the

tiles.

(NOTE: The distance between the two brackets should be 760

mm or 29.92”)

4. Using a drill with a tile bit, drill the hole slowly into the tile.

Do not drill into any piping or wiring in the wall. Insert the

anchors into the wall.

1”