Full Product Manual

5
FTF01 Rev.3.1 01/2021
Luxier
Installation
3. Make sure the oor is level in both directions.
Determine the distance from the nished wall to
the center of the oor water supply hose. Make
sure there is enough clearance around the Tub
Filler. Mark the center line. Drill a 2.5” diameter
hole for the water supply hoses. Insert the
water supply hoses through the hole and place
tub ller assembly on the oor and check for
alignment.
Level
Finished Wall Line
2.5” Hole
Base Board
Top View
3
4. With the Tub Filler Assembly aligned in the
desired position, mark each of the 4 mounting
holes from the base on the oor. Use a drill with
3/8” drill bit, drill the holes 2” deep and insert
the included anchors. Make sure the anchors are
ush with the nished oor.
5. Place the Tub Filler over the T-Connector
and connect both water supply hoses to the
T-Connector. Do not overtighten the connections.
4
2. Remove the Cap and Setscrew from the
Handle and loosen the Setscrew with the
included Hex Wrench. Insert the Handle on the
cartridge stem, tighten the Setscrew and install
Cap to the Handle. (NOTE: The top Setscrew
can be loosened to swivel the spout if needed.
Tighten the Setscrew if the position of the spout
was changed.)
Setscrew
Handle
Setscrew
Cap
Cartridge Stem
2
5