Full Product Manual

4
FTF01 Rev.3.1 01/2021
Luxier
Installation
1. Insert the Top Tube over Water Supply
Hoses. Thread the Top Tube to the Body and
tighten it fully. Slide the Escutcheon onto the
Bottom Tube and connect it to the Top Tube.
Make sure the Tubes are fully tightened.
Water Supply Hoses
Top Tube
Body
Bottom Tube
Escutcheon
1
The T-Connector needs to be tted to both the hot and cold water pipes before installing the Tub Filler. The
T-Connector should be about 3 7/8” below the surface of the nished oor and the oor opening should be
2.5” in diameter. See gure B.
IMPORTANT: This product should be installed by professional installers.
IMPORTANT: It is strongly recommended to dry t all parts before nal installation.
IMPORTANT: Provide adequate clearance around the Tub Filler.
4 1/4”
3 7/8”
1 3/4”
3 1/2”
1/2” NPT
G 3/8 Thread
2.5” Diameter Hole
Suboor
Tiled Floor
* Drawings not to Scale. All Measurements are Approximate *
Figure B. Recommended T-Connector Depth
3 1/2”
2 3/4”
1/2” NPT
G 3/8 thread
0.4”
0.6”
0.43”
1.57”
1.97”
Figure A. T-Connector Dimensions
* Drawings not to Scale. All Measurements are Approximate *
Water Pipe
Pipe Support
Figure C. Pipe Connection
Figure C. Secure water pipes to oor joist
with pipe supports. Apply PTFE tape to the
threads of the T-Connector before connecting
to the water pipes. Do not overtighten the
connections.