Full Product Manual
Luxier 028 Vessel Sink Rev.1 1020222
Installation
1. It is recommended to gather all the necessary parts on the job site to determine the proper placement prior
to installation.
2. Once the placement has been determined set the ceramic sink onto a soft surface to avoid scratches. Mark
the cutout line based on the following dimensions.
Vessel Sink with Overow and Drain Installation
vessel sink
overow
overow
channel
counter top
silicon gasket
tail pipe
brass locking nut
supporting plywood
3. Attach the pop up drain to the ceramic sink as shown in the diagram below. It is recommended to use
plumber’s putty to ll in any small gaps to prevent possible water leak. Make sure the drain is properly
secured to the vessel sink.
4. Dry t the sink to the countertop. Plumber’s putty can be used to level the sink.
5. Make sure the bottom surface of the sink is dry and free of any dust and oil. Apply silicone adhesive to the
bottom edge of the sink.
6. Turn the sink over and place the assembled vessel sink through the cutout opening on the countertop and
check for level and t. Apply silicon sealant around the bottom rim of the sink.
7. It is recommended to wait a few hours for the adhesive to cure before continue installing the faucet and
connecting the drain to the P-trap to avoid shifting of the sink.
Top View
Back of Sink
Front of Sink
17.91”
(455 mm)
23.62” (600 mm)
cutout dimension
028 Template
* All measurements are approximate. Drawing not to scale *
2.17” (55 mm)
6.5” (165 mm)
15.75”
21”
Drain hole diameter 1 3/4”
Faucet hole diameter 1 3/8”