Installation Guide

BPT01 Rev. 1A 102022
3
4
5
B
Dimensions
Parts
Installation
Installation
1. Rubber Washer
2. Tailpiece Locking Nut
3. Tailpiece
4. Inlet Locking Nut
5. Plastic Sleeve
6. Bottle Drain Body
7. Rubber Seal
8. Outlet Locking Nut
9. Outlet Pipe
10. Flange
11. Stub-out
12. O-ring
13. Drain Cover
3. Fig. B. Slide inlet locking nut (4) onto
tailpiece (3) rst and slide the plastic sleeve (5)
onto the tailpiece.
4. Slide the tailpiece assembly onto the drain
body (6) and hand tighten the inlet locking nut
(4). Align the outlet toward the waste drain
opening in the wall. Fig. C.
5. Slide the outlet locking nut (8) and rubber
seal (7) onto one end of the outlet pipe (9).
(NOTE: rubber seal (7) must be installed with
tapered end pointing to the bottle drain body as
shown.) Insert the outlet pipe (9) fully into the
drain body (6) and measure the length of the
outlet pipe needed to reach the waste drain.
Add 1 inch to the measurement and cut o the
excess pipe with a hacksaw. This will ensure
the outlet pipe is fully instered into the waste
drain.
1. Install the drain to the sink according to the
manufacturer installation instruction.
2. Install the tailpiece (3) to the drain as shown in
Fig. A. Make sure the rubber washer (1) installed
properly at the joint and tightened the tailpiece
locking nut (2).
NOTE: The length of the tailpiece (3) can be cut
to a shorter length with hacksaw to t dierent
installation height.
32
max. 12.8”
2.75”
1.25”
1.25”
1.97”
5.25”
max.
12.25”
* Drawings not to Scale. All Measurements are Approximate *
1
2
3
A
Drain Body
Tailpiece Assy.
Locking Nut
C
Outlet Pipe
Drain Body
D
1
2
3
4
5
6
7
8
9
10
12
11
13