Use and Care Manual

1.Use a tape measure to measure the distance between the two hooks on
the back of the mirror and mark the same horizontal distance on the wall
with a pencil
2.Use an power drill to drill holes in the marked spots on the wall, and then
insert the expansion anchors into the wall.
3.Use a power drill or screwdriver to rotate the expansion screws into the
expansion anchors.
4.Hang the mirror on the drilled expansion screws. Note: You do NOT need
to remove the U-shape stand on the back of the mirror before hanging.

1.Spray some water containing detergent on the surface of the mirror, we
recommend vinegar-water solution or conventional glass cleaner.
2.Wait a few seconds for the water to soften the stain, then wipe the stain
with a clean cloth. For better cleaning results, we recommend microber
cleaning cloths or newspaper.
If you have any questions please contact：
[e-mail]