Installation Manual

Half For Dimming Use (HFDU)
Mounting
1.
Push wires into wallbox, allowing room for receptacle to be
inserted. Do not pinch wires between wallbox and receptacle.
2. Mount receptacle to wallbox using screws provided.
3. Replace wallplate adapter (if removed) and snap on wallplate.
Receptacle for
Dimming Use
(NTR-15-DFDU
shown)
Wallplate Adapter
Wallplate
Wallplate Adapter
Mounting Screws
Receptacle
Mounting Screws
Cleaning Instructions
Clean receptacles with a soft damp cloth only . Do not use any
chemical cleaners.
** NOTE: To control each outlet of the receptacle independently, cut off the con-
necting link between the brass screws with a wire cutter.
Ground (Green or Bare)
Live
(Black)
Neutral (White)
125 V~
60 Hz
Dims lower outlet
** See Note Below
(NTR-15-DFDU shown)
Before
After
Dimmed Live
Dimmed Live
Dims upper outlet
Each outlet will dim independently.
Wiring Diagrams
Wiring Notes:
1. Wire terminals accept #10 AWG, #12 AWG or #14 AWG wire. Solid
copper or copper clad wire only.
2. See device for proper strip length of wires.
Ground (Green or Bare)
Live
(Black)
Neutral (White)
Lutron
Dimming
Product
Dimmed Live
(NTR-15-DFDU shown)
Loads plugged into these outlets will dim together.
125 V~
60 Hz
Duplex For Dimming Use (DFDU)
Ground (Green or Bare)
Live
(Black)
Neutral (White)
Lutron
Dimming
Product
Dimmed Live
Live
(NTR-15-HFDU shown)
Top outlet will dim and bottom outlet will remain
live.
125 V~
60 Hz
Ground (Green or Bare)
Live
(Black)
Neutral (White)
Lutron
Dimming
Product
Switch
Dimmed Live
Switched Live
(NTR-15-HFDU shown)
Top outlet will dim and bottom outlet is controlled
by a switch.
125 V~
60 Hz