Cut Sheet

4
|
Lutron® 24/7 Technical Support—800.523.9466
product specifications
9.01.11
369-228e
Load Type and Capacity
RadioRA® 2 Hybrid Keypads
Load Type Minimum Load Not Ganged End of Gang Middle of
Gang
With Neutral Without Neutral
Incandescent
1
15 W 50 W 450 W 350 W 250 W
MLV
2
15 W / VA 50 W / VA 350 W / 450 VA 250 W / 350 VA 200 W / 250 VA
Control Phase Adaptive
Power Modules
(PHPM-PA-120-WH
& PHPM-PA-DV-WH)
3-wire Fluorescent
Power Modules
(PHPM-3F-120-WH
& PHPM-3F-DV-WH)
Switched Power
Module
(PHPM-SW-DV-WH)
0-10 V Interface
and Switching
Module
(GRX-TVI)
RRD-H1RLD
RRD-H2RLD
RRD-H3BSRL
RRD-H4S
RRD-H5BRL
RRD-H6BRL
   
Compatible Power Boosters and Load Interfaces
Some local controls can be used to control power boosters or load interfaces. Up to three power
boosters or load interfaces can be used with one control. See table below for a list of compatible
power boosters and load interfaces.
1 Load Type: Hybrid Keypads are designed for use with permanently installed incandescent, magnetic low-voltage, or tungsten halogen only.
To reduce the risk of overheating and possible damage to other equipment, do not install Hybrid Keypads to control receptacles or motor-
operated appliances.
2
Low-Voltage Applications: Use Hybrid Keypads with magnetic (core and coil) low-voltage transformers only. Not for use with electronic
(solid-state) low-voltage transformers. Operation of a low-voltage circuit with lamps inoperative or removed may result in transformer
overheating and premature failure. Lutron strongly recommends the following:
•Do not operate low-voltage circuits without operative lamps in place.
 •Replace burned-out lamps as quickly as possible.
•Use transformers that incorporate thermal protection or fused transformer primary windings to prevent transformer failure due to overcurrent.