User Guide

3691183a 8 04.16.21
Lighting Control Systems QS DIN Rail Panel Power Equipment
SPECIFICATION SUBMITTAL
Job Name:
Job Number:
Model Numbers:
• For indoor use only.
• Consult dimensions page for panel size, conduit
knockouts, and mounting hole locations.
• Panels weigh up to 110 lb (50 kg). Reinforce wall
structure for weight and local codes.
• Mount panel where audible noise is acceptable.
• This equipment is passively air-cooled. Mount in a
location where the vented cover will not be blocked.
12in (305mm) of clearance in front of the vents is
required. Vents must not be blocked or the warranty
will be voided.
• Mount the panel so that line-voltage wiring will be at
least 6 ft (1.8 m) from audio and video equipment, or
radio frequency devices equipment and wiring.
• For surface mount, mount the panel a minimum of 6 in
(152mm) from the floor and 12in (305mm) from the
ceiling.
• Mount panel using one of the methods below
(mounting hardware is not pro vid ed):
Surface-Mounting
• Lutron recommends using 1/4 in (6mm)
mounting bolts.
• Use keyholes with bolts sufficient for 110 lb (50 kg)
load, M6 (1/4 in) bolts rec om mend ed.
• Mount within 7º of true vertical
Recess-Mounting
• Mount panel between flush and 1/8 in (3.2mm)
below finished wall surface.
• Use screws sufficient for 110 lb (50 kg).
• Install in accordance with all local and national
electrical codes.
• Limit vertical stacking of PD2 panels to three panels
high and limit vertical stacking of PD4 panels to two
panels high, while maintaining at least 12 in
(305 mm) of air space at the top and bottom of
each panel. Do not vertically stack PD6, PD8, or
PD10 panels.
Preferred Feed Wiring
Preferred Feed Wiring
Do Not
Block
Vents
Minimum
Clearance
12 in
(305 mm)
NEC® Class 2
Wiring
NEC® Class 2
Wiring
Terminal
blocks for
dimming
legs to
loads
Feed
Wiring
(feed-
through
only)
and load
wiring
Terminal
blocks
for loads
Front View
Front View
Side View
Side View
Mounting for Panels
Minimum
6 in
(152 mm)
Minimum
12 in
(305 mm)
Do Not
Block
Vents
Minimum
Clearance
12 in
(305 mm)
Minimum
6 in
(152 mm)
Surface-Mounting Recess-Mounting
Minimum
12 in
(305 mm)
8