Installation Manual
Control
Faceplate Adapter
Slider
Faceplate
Adapter Mounting
Screws
Control Mounting
Screws
Operation
Slide-to-Off Controls
Raise slider to increase light intensity. Lower slider to decrease light
intensity and turn off.
Preset Dimmers
Push button in center of slider to alternately turn lights on to preset
level (set by slider) or turn lights off. Raise slider to increase light
intensity. Lower slider to decrease light intensity.
3-Way and 4-Way Switches
When switching power from remote location, lights will turn on to
level set on dimmer (by slider), or turn off. Move slider up or down
to turn lights on or off. Note, use only one dimmer per circuit.
Fluorescent Dimmers
Dimmers are factory calibrated and do not require low-end light
adjustment. If lamps flicker or drop out at the minimum dimming
level there may be an installation error. Continued use of the system
in this mode will cause premature lamp failure. If this is occurring,
call the
Lutron Technical Support Center
at: 1.800.523.9466.
To ensure proper dimming performance and full lamp life, fluores-
cent lamps must be operated at full intensity for 100 hours prior to
dimming.
Installation
If more than one control is to be installed in the same wallbox,
review the Multigang Installation section (back page) before begin-
ning. Lutron multigang faceplates are available for ganging multiple
units.
1. Turn power OFF at circuit breaker or remove fuse.
WARNING: Wiring with power on may result in personal injury.
Damage to this product caused by wiring with power on voids
warranty.
2. Remove faceplate and faceplate adapter from control to prevent
damage and to access mounting holes. Pull from top of face-
plate to remove. Unscrew faceplate adapter. Set aside.
3. Wire control per appropriate wiring diagram (see previous page)
using wire connectors provided.
Note: Color names refer to the wire colors on the control.
4. Push wires into wallbox, allowing room for control to be inserted.
Do not pinch wires between wallbox and control.
5. Mount control to wallbox using control mounting screws provid-
ed. Controls must be mounted vertically. See stamp on control
for correct positioning.
6. Mount adapter plate with adapter mounting screws provided
(see below).
7. Snap on slider and faceplate.
8. Turn power ON at circuit breaker or replace fuse.