Installation Guide

Note: Only one dimmer per 3-Way circuit. Position of NLV-603P,
NLV-1003P, NLV-1503P, NLV-2003P and a 3-Way switch may be
reversed in wiring diagram. 4-Way switches must be wired
between NLV-603P, NLV-1003P, NLV-1503P, NLV-2003P and a 3-
Way switch.
Figure 2. 3-Way Wiring
For use with 4-way switches, see Figure 3.
Mounting Diagram
Operation
1.
Turn on power, push preset button in center of slider to turn
lights on to the level set by slider.
2. Raise slider for brighter light, lower for dimmed light. Push
button again to turn lights off.
3. For 3-Way applications: When switching power from a
standard 3-way switch, light will come on at the level set by
slider on the dimmer.
Note: When it is necessary to replace lamps or service the
controlled fixtures, turn OFF circuit breaker or remove fuse.
Black
Hot
Neutral
Red
Red
Lamps
Ground
Slider
Wallplate
Preset Button
Ground
120 V~
60 Hz
120 V~
60 Hz
Transformer(s)
N-3PS or
standard 3-way
switch
Black
Hot
Red
Red
N-4PS or standard
4-way switch
Neutral
N-3PS or standard
3-way switch
Ground
Lamps
Ground
Ground
Transformer(s)
Figure 3. 4-Way Wiring
2
Center Mounting Hole
To Replace Existing 3-Way Switch:
For wiring a NLV-603P, NLV-1003P, NLV-1503P, or NLV-2003P in a
3-way application, the wall switch has three screws; two of one
color and a third of a different color. It also has a green ground
screw.
Using the wire connectors provided:
• Connect the wire from the green ground screw to the green or
bare ground wire of the dimmer.
• Connect the wire from the odd color switch screw to the black
wire of the dimmer.
• Connect wire from one of the remaining switch screws to one of
the red wires of the dimmer.
• Connect wire from the last switch screw to the last red wire of
the dimmer.
6. Push wires into wallbox allowing room for dimmer to be
inserted.
7. Mount dimmer to wallbox using two screws provided and the
center mounting screw holes. Unit MUST be mounted
vertically.
8. Snap wallplate on over fins. When ganging, slide wallplate up
or down to align them.