Installation Manual

18
Application Note #480
www.lutron.com
®
Restoring Default Settings
Default settings
Programming Mode
Timeout. . . . . . . . . . . . . . . . . . . . 5 minutes
Sensitivity . . . . . . . . . . . . . . . . . . . High
Auto On . . . . . . . . . . . . . . . . . . . Enabled
Occupied Level . . . . . . . . . . . . . . . . 100%
APM
Preset Light Level. . . . . . . . . . . . . . . None selected
Manual Fade to ON time . . . . . . . . . . . 0.75 seconds
Manual Fade to OFF time. . . . . . . . . . . 2.5 seconds
Delayed Fade to OFF time . . . . . . . . . . 30 seconds
Nightlight Mode. . . . . . . . . . . . . . . . Enabled
Low-End Trim. . . . . . . . . . . . . . . . . IL3
High-End Trim . . . . . . . . . . . . . . . . IL7: Brightest High-End
Restoring Default Settings
Note:
• If you perform the reset sequence, you will return your APM settings to their defaults; you may need to adjust Low‑End Trim
settings to accommodate your particular bulbs.
5 sec 15 sec
T T
1. Pull the FASSTM into the OFF
position (Out); wait 5 seconds.
2. Press and hold the
T
button;
continue to hold the
T
button and
push the FASSTM back in to the ON
Position; continue to hold the
T
button for approximately 15seconds.
Note: The dimmer will enter APM
after the first 5 seconds; continue to
hold the
T
button for the remaining
10seconds until the lights in the
room turn OFF and back ON.
3. Load (light) will turn OFF and turn
back ON to full intensity. This action
represents a successful reset.