Specification Sheet

®
SPECIFICATION SUBMITTAL Page
Job Name:
Job Number:
Model Numbers:
Dual-Circuit Switch with Occupancy/Partial-On Sensor
369758c 3 01.02.14
Maestro® Sensor
* Default settings shown in this section are locked in the MS-PPS6-DDV
(Partial-ON only) to satisfy the CEC 2013 Title 24 definition for a
“Partial-ON” sensor
1
Default setting for circuit 1
2
Default setting for circuit 2
Custom Settings at-a-glance
Circuit 1 Circuit 2
Timeout
Test mode Test mode
1 min 1 min
5 min 5 min
15 min 15 min
30 min 30 min
Sensitivity
High
Low
Sensor
Modes*
Auto-ON/Auto-OFF
(Occupancy)
1
Auto-ON/Auto-OFF
(Occupancy)
Manual-ON/Auto-OFF
(Partial-ON)
Manual-ON/Auto-OFF
(Partial-ON)
2
Advanced
Auto-ON
Modes
Ambient Light Detection (ALD)
Off-While-Occupied Enabled (OWO)
Off-While-Occupied Disabled
Custom Settings
(defaults shown in Bold)
• Timeout (applies to individual circuits)
– Test mode
– 1 min
– 5 min
– 15 min
– 30 min
• Sensor Modes* (apply to individual circuits)
– Auto-ON / Auto-OFF
1
(Occupancy mode)
– Manual-ON / Auto-OFF
2
(Partial-On mode)
• Advanced Auto-ON Modes (apply to all Auto-ON
circuits)
– Ambient Light Detection (ALD) mode:
· Lights turn on only when natural light in the
room is low
· Smart-Ambient light threshold adjusts to the
user’s preference
– Off-While-Occupied Enabled (OWO)
· When the Occupancy Sensing Switch is
manually turned off, the Occupancy Sensing
Switch will not turn the lights back on
automatically while the room is occupied.
· Once the room is vacated, the Auto-ON feature
returns to normal operation after the timeout
period has expired.
· This may be the preference in conference
rooms or classrooms while viewing
presentations.
– Off-While-Occupied Disabled
· When the Occupancy Sensing Switch is
manually turned off, the Auto-ON feature will
return to normal operation after 25 seconds.
· When the unit is manually turned off, after 25
seconds the unit will turn back on if motion is
detected.
· This setting may be the preference for
high-traffic areas where it is important to ensure
that the lights always respond to occupancy
(e.g., bathroom, laundry room, utility closet).
• Sensitivity (applies to both circuits)
– High sensitivity
– Low sensitivity
– Restore ALL defaults
3