Cut Sheet

Maestro RF 0–10 V Sensor Dimmer / RF Sensor Switch SensorVive
3691097a 4 01.24.19
SPECIFICATION SUBMITTAL Page
Job Name:
Job Number:
Model Numbers:
Note: This is how to program these settings in
standalone applications (not part of the Vive system).
For a complete list and description of available
settings for standalone applications, refer to
Application Note #687 (048687) at www.lutron.com
For set-up, programming, and troubleshooting
with a Vive system, please refer to the installation
instructions included with the Vive hub or
at www.lutron.com
: Timeout
• 30 min
• 15 min
• 5 min
• 1 min
Mode: Sensor Modes
1
Lights automatically turn off in all sensor modes
• Occ: Occupancy mode (Auto-On/ Auto-Off)
• Lrn: Occupancy with learning ALD mode
• Fixd: Occupancy with fixed ALD mode
• Vac: Vacancy mode (Manual-On/ Auto-Off)
PIR: Passive Infrared Sensitivity
• High
• Med
• Low
• Min
Custom Settings (default settings shown in bold )
Fixed ALD Light Level
2,3
• High
• Med
• Low
4
• Min
Walk-Thru Mode (MRF2S-8SD010 and
MRF2S-8SS only)
2
• Enabled
• Disabled
Occupied Level
5,6
A programmable setting that determines the light
level the sensor dimmer will turn on to, once
occupancy has been detected
Vacancy Light Level
6
The level to which the sensor dimmer dims or turns
off when motion has not been detected for the
timeout period
Electronic Off
2,6,7
• Enabled
• Disabled
Low-End Trim
6,8
• Fully adjustable from 1% to 45%
High-End Trim
6,8
• Fully adjustable from 55% to 100%
1
Sensor Mode is locked as “Vacancy” in vacancy only models
(MRF2S-8SDV010 and MRF2S-8SSV), in standalone applications.
This restriction is removed in the Vive system.
2
Setting not available once device is configured in the Vive system.
3
ALD is when the sensor determines how much ambient light is enough,
based on a fixed level you select. If there is enough light, it will NOT turn
the lights On.
4
Low is the default setting for any sensor that is set by the user to
“Occupancy with fixed ALD mode”.
5
Fully adjustable from 1% to 100% within the adjustable range of low-end
and high-end trim.
6
Only available with the sensor dimmer. Not available with sensor switch.
7
When enabled, electronic off keeps the product relay closed and dims to
the low-end the loads that support electronic off. When disabled, it uses
the product relay to turn the load On and Off.
8
Setting is fully variable within each range.
4