Cut Sheet

Maestro RF 0–10 V Sensor Dimmer / RF Sensor Switch SensorVive
3691097a 3 01.24.19
SPECIFICATION SUBMITTAL Page
Job Name:
Job Number:
Model Numbers:
Specifications
Regulatory Approvals
• UL
® Listed to U.S. and Canadian safety requirements
• Complies with Title 20 and Title 24 Section 110.9
Power
• Operating voltage: 120 / 277 V~ 50 / 60 Hz,
8 A (USA), 120 V~ 50 / 60 Hz, 8 A (Canada) of
0 –10 V- electronic fluorescent ballasts or LED
drivers for sensor dimmer, and all lighting loads for
sensor switch
Loads
• Sensor Dimmer
– Works with all ballasts and drivers that provide a
current source compliant to IEC 60929 Annex E.2,
and whose inrush current does not exceed NEMA
410 standards for electronic ballast / driver loads of
8 A steady state current
– Supports Electronic Off functionality for voltages
less than 0.5 V
– 50 mA max sink current
– Controls up to 25 ballasts or drivers (IEC 60929
Annex E.2 requires the ballast / driver to limit the
current to 2.0 mA maximum)
– No minimum load
• Sensor Switch
– Works with all lighting loads
Environment
• Ambient operating temperature: 32 °F to 104 °F
(0°C to 40 °C), 0% – 90% humidity, non-condensing;
indoor use only
Warranty
• 5 Year Limited Warranty
For additional Warranty information, please visit:
www.lutron.com/TechnicalDocumentLibrary/
Sensor_Warranty.pdf
Key Design Features
Dimmer
• On a single-tap, lights fade On or Off to previous level
• On a double-tap, lights go to full On
• Light levels can be fine-tuned by pressing and
holding the dimming rocker until the desired light
level is reached
• High-end trim (adjust maximum light level that can be
achieved, for energy savings)
• Low-end trim (adjust minimum light level that can be
dimmed down, to prevent flickering lights)
Vive System Communications and Capacity
• Maestro Wireless controls communicate with the
Pico remote controls and Radio Powr Savr sensors
through radio frequency (RF).
• Receives wireless inputs from up to 10 Pico remote
controls, 10 Radio Powr Savr occupancy / vacancy
sensors, and 1 Radio Powr Savr daylight sensor.
• Maestro Wireless local controls must be located
within 60 ft (18 m) line-of-sight or 30 ft (9 m) through
walls, of Radio Powr Savr sensors and Pico remote
controls. The 60 ft (18 m) range is not reduced by a
ceiling tile obstruction.
Additional Information on Sensors
• For more information, please see
www.lutron.com/occvacsensors
• Lutron Customer Assistance: 1.844.LUTRON1
3