Cut Sheet

Maestro RF 0–10 V Sensor Dimmer / RF Sensor Switch SensorVive
3691097a 2 01.24.19
SPECIFICATION SUBMITTAL Page
Job Name:
Job Number:
Model Numbers:
Models Available
Model Number Description Sensor Operation Load Types
MRF2S-8SD010-XX
1
Occupancy/vacancy single-pole/
multi-location sensor dimmer
Auto-On / Auto-Off or
Manual-On / Auto-Off
For use with permanently installed electronic
fluorescent ballast or LED driver lighting loads
MRF2S-8SS-XX
1
Occupancy/vacancy single-pole/
multi-location sensor switch
Auto-On / Auto-Off or
Manual-On / Auto-Off
For use with all lighting loads
MRF2S-8SDV010-XX
1
Vacancy single-pole/multi-location
sensor dimmer
Manual-On / Auto-Off
For use with permanently installed electronic
fluorescent ballast or LED driver lighting loads
MRF2S-8SSV-XX
1
Vacancy single-pole/multi-location
sensor switch
Manual-On / Auto-Off For use with all lighting loads
1
XX in model number represents color/finish code. See Colors and Finishes on page 10.
Notes:
• Neutral is required for product to function. If a neutral wire is not present, consult a licensed electrician.
• When power is applied, the sensor dimmer / switch can be manually turned on or off after the first 10seconds and
will automatically control the load after 2minutes.
• The sensor dimmer works with all ballasts and drivers that provide a current source compliant to IEC 60929
Annex E.2.
• The 0 –10 V- control wires are not to exceed 250 ft (76.2 m) in length, and must have a size of no less than
20 AWG (0.75 mm
2
).
• The 0 –10 V- wires may be installed as Class 1 or Class 2 per NECR or local jurisdiction.
• Do not install dimmers / switches to control receptacles or motor-operated appliances.
2