Cut Sheet

Selecting the “On” Fade Time
1. While in Main Menu Mode, press the Raise / Lower Rocker until LED 2 is blinking.
2. Press the Tap Button once. A quickly flashing LED will indicate which fade time has been selected
(refer to picture below). LED 1 is the default setting.
3. Press the Raise / Lower Rocker to adjust the quickly blinking LED to the position that represents the desired fade time.
4. Press the Tap Button once to return to the Main Menu.
Note: The fade speed for Raise and Lower operations are not affected by any “On” Fade Time modification.
Selecting the “Off” Fade Time
1. While in Main Menu Mode, press the Raise / Lower Rocker until LED 3 is blinking.
2. Press the Tap Button once. A quickly flashing LED will indicate which fade time has been selected (refer to picture
below). LED 2 is the default setting.
3. Press the Raise / Lower Rocker to adjust the quickly blinking LED to the position that represents the desired fade time.
4. Press the Tap Button once to return to the Main Menu.
Note: The fade speed for Raise and Lower operations are not affected by any “Off” Fade Time modification.
LED 5: Slowest “On” Fade Time
LED 1: Fastest “On” Fade Time
LED
Position
“On” Fade Time*
Single Tap
“On” Fade Time *
Double Tap
5 15 seconds 5 seconds
4 5 seconds 3 seconds
3 3 seconds 2.5 seconds
2 2.5 seconds 0.75 seconds
1 0.75 seconds (default) 0.75 seconds (default)
* Time from Off to Maximum light level.
LED
Position
“Off” Fade Time*
5 15 seconds
4 5 seconds
3 3 seconds
2 2.5 seconds (default)
1 0.75 seconds
* Time from Maximum light level to Off.
LED 5: Slowest “Off” Fade Time
LED 1: Fastest “Off” Fade Time
How to Save Settings and Exit Main Menu Mode
1. Press and Hold the Tap Button for 4 seconds to exit and save the Main Menu.
Note: If you wait 1 minute the dimmer will automatically exit from APM, however settings will not be saved.
7 Technical Support — 1.844.LUTRON1
Application Note #370