Cut Sheet

Selecting a Preset Option
Note: The default setting is an Unlocked Preset. (Scrolling LEDs 1, 2, and 3)
1. While in Main Menu Mode, press the Raise / Lower Rocker until LED 1 is blinking.
2. Press the Tap Button once.
To select Locked Preset:
1. Press the Raise / Lower Rocker to adjust the light level to the desired Locked Preset. The quickly flashing LED will
move up and down as the preset is changed. Your light will get brighter or dimmer to reflect the Locked Preset level as
you adjust this feature.
2. Press the Tap Button once to return to the Main Menu.
To select Unlocked Preset:
1. Press the Lower Rocker until the bottom LED is quickly flashing. Release the lower button and press and hold the
lower button again for approximately 3 seconds or until LEDs 1, 2, and 3 start scrolling. Please note that the light will
remain at its minimum output when you perform this action.
2. Press the Tap Button once to return to the Main Menu.
How to Save Settings and Exit Main Menu Mode
1. Press and Hold the Tap Button for 4 seconds to exit and save the Main Menu.
Note: If you wait 1 minute the dimmer will automatically exit from APM, however settings will not be saved.
Entering Selection Menu Mode
1. Press the Raise / Lower Rocker to change the LED
Position to indicate which feature you would like to
modify (refer to picture below).
2. Press the Tap Button once and the feature will be
selected for modification.
LED 7: High-end Trim
LED 6: Low-end Trim
LED 5: LED Brightness
LED 4: Delayed Fade to Off
LED 3: “Off” Fade Time
LED 2: “On” Fade Time
LED 1: Preset Option
6 www.lutron.com
Application Note #370