Cut Sheet

The user has the option of associating a Radio Powr SavrTM occupancy sensor to multiple Maestro Wireless®
dimmers / switches, and set up the system so that only selected loads automatically turn on. Other loads would require
the user to manually turn on the load. When the room is vacant, all loads turn off.
Selecting the Unaffected Dimmer*
1. Turn off the dimmer.
2. Press the Lower Rocker Button for 3 seconds or until the middle three LEDs illuminate.
3. Press and hold the “Test” Button on the Radio Powr SavrTM occupancy sensor until the dome flashes.
Selecting the Unaffected Switch *
1. Turn off the switch.
2. Pull the FASS
TM into the “Off” Position.
3. Press and Hold the Tap Button of the product while pushing the FASSTM to the “On” Position until the LED on the
switch starts to blink.
4. Press and hold the “Test” Button on the occupancy sensor until the dome flashes.
* Does not require entering into Main Menu Mode or SCM.
Setting Unaffected Mode
Entering Main Menu Mode (refer to picture on Page 1)
1. Pull the FASSTM into the “Off” Position.
2. Press and Hold the Tap Button of the product you are programming.
3. Push the FASSTM to the “On” Position while continuing to hold the Tap Button for approximately 5 seconds.
The bottom LED will begin to blink to indicate that you have entered APM.
Note: If there is no activity for 1 minute, the dimmer will automatically exit APM.
How to Save Settings and Exit Main Menu Mode
1. Press and Hold the Tap Button for 4 seconds to exit and save the Main Menu.
Note: If you wait 1 minute the dimmer will automatically exit from APM, however settings will not be saved.
5 Technical Support — 1.844.LUTRON1
Application Note #370