Cut Sheet

If you would like to return the dimmer / switch to its original factory settings, please do the following:
Dimmer / Switch
Note: If the dimmer / switch is restored to factory defaults, not only will the APM settings return to default settings,
but any Pico
® wireless controllers, occupancy, vacancy, and daylight sensors will no longer be associated to the
dimmer / switch.
a. Press the Tap Button three times in quick succession and hold on the third press. Continue to hold the Tap
Button until the LED(s) and Load begin to cycle.
b. Quickly press the Tap Button three more times in quick succession and release after the third press.
c. Confirmation: The LED(s) and Load will cycle three times then turn on.
Note: The Tap Button MUST continue to be held until the second sequence of three presses is begun or the unit
will exit the mode and the procedure WILL NOT be successful.
Removing One Transmitter from Specific Dimmers / Switches within Range
Note: If the transmitter is associated with multiple devices, any device within listening range will also remove its
association to that particular transmitter.
a. To avoid dissociation of the transmitter from any device within listening range, pull the FASS
TM of that device
into the “Off” Position or Unplug the Maestro Wireless®device from the wall outlet.
b. Press the “On” Button on the transmitter three times in quick succession and continue holding the button on
the third press. Please refer to the transmitter’s instructions for the appropriate response.
c. Test the transmitter to verify that all of the appropriate devices have been dissociated from the transmitter.
d. Upon confirming success in the previous step, push the FASS
TM into the “On” Position or Plug the Maestro
Wireless® device into a standard wall outlet for any remaining devices with an association to the transmitter.
1. Ensure sensor is associated to the dimmer prior to attempting to set the occupied light level. See product install
guide for instructions to do so.
2. Adust the dimmer to the desired occupied light level.
3. Press and hold the Test Button on the Radio Powr Savr
TM occupancy sensor until the lens starts to flash.
4. An LED on the dimmer will flash to indicate that the light level has been saved.
Test
Setting the Occupied Light Level With a Radio Powr SavrTM Occupancy Sensor
Restoring Factory Defaults
4 www.lutron.com
Application Note #370