Cut Sheet

How to Save Settings and Exit SCM

1. Press and Hold the Tap Button for 4 seconds to exit and save the APM.

Note: If you wait 1 minute the dimmer will automatically exit from APM, however settings will not be saved.

Overriding Daylighting Mode (Available for products with M6 revision software or later):

1. Press the Raise / Lower Rocker until LED 6 begins to blink.

Note: LED 7 will also be blinking indicating that the product is in SCM.

2. Press the Tap Button once in order to determine the current override setting. An LED will begin to blink quickly

indicating the current override setting.

3. Press the Raise / Lower Rocker to adjust the override setting. The position of the quickly blinking LED will move

indicating the selected override setting.

4. Press the Tap Button once to return to the SCM Menu.

LED

Position

Daylighting

2 Enabled

1 Disabled (Default)

LED 7: System Configuration Mode

LED 2: Enabled

LED 1: Disabled

Overriding Daylight Timers (Available for products with M6 revision software or later):

1. Press the Raise / Lower Rocker until LED 5 begins to blink.