Cut Sheet

How to Save Settings and Exit SCM

1. Press and Hold the Tap Button for 4 seconds to exit and save the APM.

Note: If you wait 1 minute the dimmer will automatically exit from APM, however settings will not be saved.

Adjusting Product Mode (Available for Corded Dimmers with M6 software or later only):

1. Press the Raise / Lower Rocker until LED 3 begins to blink.

Note: LED 7 will also be blinking indicating that the product is in SCM.

2. Press the Tap Button once in order to determine the current mode of the product. An LED will begin to blink

quickly indicating the current mode of the product.

3. Press the Raise / Lower Rocker to adjust the mode of the product. The position of the quickly blinking LED will

move indicating the selected mode of the product.

4. Press the Tap Button once to return to the SCM.

LED

Position

Mode Type

2 Switch Mode

1 Dimmer Mode (Default)

Note: Alternatively the user may triple tap the Tap Button and hold for 30 seconds to cycle between the switch and

dimmer modes without the need to enter APM.

LED 7: System Configuration Mode

LED 2: Switch Mode

LED 1: Dimmer Mode

Entering System Configuration Mode (SCM) Menu

Note: System Conﬁguration Mode (SCM) features apply to those products with M6 revision software or later.

1. While in Main Menu Mode, press the Raise Rocker until LED 7 begins to blink then release. Press and hold the

Raise Rocker again for 3 seconds. LEDs 1 and 3 will begin to blink, requiring confirmation to enter SCM.

Note: Upon entering SCM the product cannot be returned to the Main Menu Mode until APM has been exited by

performing power cycling or pressing and holding the Tap Button. To exit at any point simply power cycle the

product.

2. Press the Tap Button on the product once to enter SCM. LED 7 and a user selectable LED will begin to blink.

Note: If a menu item does not pertain to the product the menu item will not be available for selection.

LED 7: System Configuration Mode

LED 6: Overriding Daylighting Mode

LED 5: Overriding Daylighting Timers

LED 4: Vacancy Light Level Preset

LED 3: Product Mode

LED 2: N/A

LED 1: N/A

10 www.lutron.com

Application Note #370