Cut Sheet
Maestro Wireless® dimmers contain APM features that allow the user to customize their control to meet their specific
needs. This document serves as a supplement to the instruction sheet. APM features apply to only those products with
M4 revision software or later while System Configuration Mode (SCM) features apply to those products with M6 revision
software or later. Please note that the software revision level can be found on the outside of the unit and will always start
with the letter M. Before entering either mode, it is important to have a good understanding of the features included. For a
summary of these features and further instructions, see the pages corresponding to your product.
Dimmer
B
R
L
F
Key
B = Tap Button
R = Raise Rocker
L = Lower Rocker
F = Front Accessible
Service Switch (FASS
TM)
Pull OFF/Push ON
Note: The MRF2-3LD and MRF2-3PD products do not have a FASSTM. In order to cycle power please follow the
steps below:
1. Unplug the Maestro Wireless
®device from the wall outlet.
2. Wait for 3 seconds.
3. Plug the Maestro Wireless®device into a standard wall outlet.
B
R
L
Lamp Dimmer
COOPERSBURG, PA 18036 USA
®
MRF2-3PD
Wireless
®
B
R
L
Plug-In Dimmer
Maestro Wireless® Advanced Programming Mode (APM)
Application Note #370
Revision D
February 2016
1 Technical Support — 1.844.LUTRON1