Cut Sheet

SPECIFICATION SUBMITTAL Page
Job Name:
Job Number:
Model Numbers:
3691112a 6 01.09.19
Wallbox ControlsPhase-Selectable Dimmer
Maestro
Advanced Programming Mode
Maestro dimmers and switches contain an Advanced Programming Mode (APM) that allows users to customize
the control to meet their specific needs. For a detailed description of APM features and uses please refer to Lutron
Application Note #703 (P/N 048703) at www.lutron.com
Instructions for selecting phase:
1.
Open the FASS.
2. Press and hold . Close the FASS and continue to
hold
for 5 seconds.
Note: The current phase selection will illuminate.
IL7 (top, forward-phase) or IL1 (bottom, reverse-phase)
3. Press the or to get the desired selection.
4. Press
T
to exit Phase Selection mode.
F
A
S
S
T
M
•
F
A
S
S
T
M
•
F
A
S
S
T
M
•
F
A
S
S
T
M
•
F
A
S
S
T
M
•
F
A
S
S
T
M
•
Tap Switch
Raise lights
Lower lights
T
Forward-
Phase
Reverse-
Phase
Available Advanced Features
Feature Description
High-end trim Select the maximum available light limit.
Low-end trim Select the minimum available light limit.
Enable / Disable / Dim Indicator Lights Select the brightness of the LEDs when the dimmer is Off.
Delayed long fade-to-off Set the length of time to wait before entering a long fade-to-off.
Fade off time Control the rate at which the dimmer fades from full intensity to Off
when the tapswitch is pressed.
Fade on time Control the rate at which the dimmer fades from Off to preset
intensity when the tapswitch is pressed.
Protected preset Set the intensity that the dimmer will always turn on to when the
tapswitch is pressed once.
Phase selectable Select between forward and reverse dimming phase.
Default is reverse.
Restore default Select to return dimmer to its original factory settings
Indicator Lights (IL)
IL7
IL6
IL5
IL4
IL3
IL2
IL1
6