Advance Installation

Wireless
11
7
Remove side sections (if necessary)
Do not remove outside side sections
on switches at the end of gang.
Each switch has inside
side sections removed.
Switch in the middle has
all side sections removed.
8
Connect the new CasétaTM Wireless switch
Tagged Wire
Ground
(Green Wire)
9
Mount the CasétaTM Wireless switch
10
Attach the wallplate
‘snap’
11
Remove existing toggle switch from wall at Location 2
3-Way Installation - CasétaTM Wireless In-Wall Switch with Mechanical Toggle Switch
12
Modify wiring for existing toggle switch
Ground (Green / Bare Copper)
Different
Color
Screw
When installing more than one Caséta
TM Wireless switch in the same
wallbox, it is necessary to remove inner side sections prior to wiring. See
image and chart below for more information.
Wallplate
Adapter
Wallplate
Location 1
Location 1
Location 2
Add jumper wire as shown
Location 2
Location 1
Important note:
Removing side sections reduces the switch’s maximum wattage
rating. See the chart below for maximum wattage information.
B
B B
C
B
A
PD-5WS-DV (120 V~)
CFL / LED 5 A 4 A 3 A
Halogen/incandescent 600 W 450 W 350 W
Electronic Low-Voltage 600 W 450 W 350 W
Magnetic Low-Voltage
1
600 VA / 475 W 450 VA / 350 W 350 VA / 275 W
Fluorescent
2
5 A 4 A 3 A
General Purpose Fan 3 A 3 A 3 A
PD-5WS-DV (277 V~)
CFL / LED 5 A 4 A 3 A
Halogen/incandescent 1350 W 1100 W 800 W
Electronic Low-Voltage 1350 W 1100 W 800 W
Magnetic Low-Voltage
1
1350 VA / 1075 W 1100 VA / 875 W 800 VA / 625 W
Fluorescent
2
5 A 4 A 3 A
A
B C
A
B C
1
The maximum lamp wattage is determined by the efficiency of the transformer, with
70% – 85% as typical. For actual transformer efficiency, contact either the fixture or
transformer manufacturer. The total VA rating of the transformer(s) shall not exceed the VA
rating of the in-wall switch.
2
The in-wall switch is ULR Listed for use with all magnetic and electronic fluorescent ballasts.
Black
Blue
Black
Different
Color
Screw