Drawing
2
Customer Assistance:
1.844.LUTRON1 (U.S.A. / Canada)
www.lutron.com/support
product specifications
12.01.17
369246c
RadioRA 2 RF Plug-In Modules
Specifications
Model Numbers RR-3PD-1-XX, RR-15APS-1-XX
Power 120 V~ 50 / 60 Hz
Typical Power
Consumption
0.3 W
Test conditions: load is off.
Regulatory Approvals cUL, UL, FCC, IC, SCT, NOM (-3PD only; -15APS pending)
Environment Ambient operating temperature: 32 °F to 104 °F (0 °C to 40 °C),
0% to 90% humidity, non-condensing. Indoor use only.
Communications
Plug-In Modules communicate with the system through Radio Frequency
(RF) and must be located within 30 ft (9 m) of a repeater. System devices
operate on frequencies between 431.0 MHz and 437.0 MHz.
ESD Protection Tested to withstand electrostatic discharge without damage or memory
loss, in accordance with IEC 61000-4-2.
Surge Protection Tested to withstand surge voltages without damage or loss of operation,
in accordance with IEEE C62.41-1991 Recommended Practice on
Surge Voltages in Low-Voltage AC Power Circuits.
Power Failure Power failure memory: should power be interrupted, the RF Plug-In
Module will return to its previous state when power is restored.
Warranty www.lutron.com/TechnicalDocumentLibrary/Warranty.pdf
Dimming Module (RR-3PD-1)
•
On a single-tap of the toggle button, lights
fade ON or OFF.
•
On a double-tap of the toggle button, lights
go to full ON.
•
When ON, press and hold the toggle button
to engage the delayed long fade to OFF.
•
Light levels can be fine-tuned by pressing
and holding the raise / lower buttons until the
desired light level is reached.
•
Control non-dimmable lighting loads in
switching mode.
Design Features
Appliance Module (RR-15APS-1)
•
On a single-tap of the toggle button, load toggles
ON or OFF.
•
The appliance module may be used with, but is not
limited to, the following:
–
Task lighting
–
Humidifiers
Note: Refer to the manufacturer’s guidelines for
acceptable switching methods.
•
The appliance module may NOT be suitable for use
with devices that require any of the following:
–
Shut-down process before power is interrupted,
such as computers.
–
Cool-down process before power is interrupted,
such as projectors.
–
Programming, such as clocks or DVRs.
–
Long warm-up cycle.
•
If an over-temperature condition is detected,
the LED on the unit will flash a unique sequence
(double-blink, then pause) and turn the load
off. Proper installation and conformance to
all specifications should be ensured before
proceeding. To return the device to normal
operation, cycle power to the device.
–
Monitors
–
Fans
–
Printers