User Manual

Lutron Electronics Co., Inc. 7200 Suter Road
Coopersburg, PA 18036-1299 USA
Release Wires from Connectors
Press connector buttons while pushing the wires slightly inward. Pull wires outward to release the wires from the
connectors. Do NOT pull out the wires without using the connector buttons, as damage to the product
can occur.
Packaging
Fixture packaging must protect the installed wireless fixture control so that it does not get damaged in shipping.
Customer Assistance | 1.844.LUTRON1 USA, Canada, and the Caribbean | +44.(0)20.7702.0657 Europe | +1.610.282.3800 Others | www.lutron.com
Part of the Vive Family
Clear Connect Wireless Fixture
Controllers
Required Components
For each fixture, you will need:
Clear Connect Wireless Fixture
Controller (with Occupancy Sensor)
(DFCSJ-OEM-OCC)
Clear Connect Wireless Fixture
Controller (RF Only)
(DFCSJ-OEM-RF)
Start Here
English
Important Notes:
• Forinstallationbyaqualiedxturemanufacturer.
• Usecopperconductorsonly.
• Checktoseethatthedevicetypeandratingissuitablefortheapplication.
• DO NOTinstallifproducthasanyvisibledamage.
• Ifmoistureorcondensationisevident,allowtheproducttodrycompletely
before installation.
• Operatebetween32°Fand131°F(0°Cand55°C),ambient.
• 0%to90%humidity,non-condensing.
• Forindooruseonly.
• Sensorshouldbemountedtoxtureinorientationthatmakesitparallelto
theoorwhenxtureisinstalledinceiling.
DFCSJ-OEM-OCC Clear Connect Wireless
Fixture Controller (with Occupancy Sensor)
DFCSJ-OEM-RF Clear Connect
Wireless Fixture Controller (RF Only)
InstallClearConnectWirelessFixtureController
• Ensureknockoutandadjacentsurfacesarefreefromburrs,oil,chemicals,debris,etc.
• DonotpushonthePIRlensorbuttontoinstallthewirelessfixturecontrol.Pushonthecenterofthe
wireless fixture control.
Connector(poke-instyle)
• 18to22AWG(0.75to0.3mm
2
)solidcopperwire
• Wirestriplength:0.31in(8mm)
Mounting Thickness
Snapsenablemountingtothefollowingmaterialthicknessranges:
• 0.04in(1mm)orless
• 0.041to0.08in(1.1to2mm)
• 0.081to0.13in(2.1to3.3mm)
WARNING! Shock Hazard. May result in serious injury or death.
Turn off power at circuit breaker before installing the unit.
Formoreinformation,see
www.lutron.com/TechnicalDocumentLibrary/3691039.pdf
Please read before installing.
+
One Fixture Control
At least one EcoSystem driver + Wireless Sensor Interface (PS-OEM-2W-UNV)
Or
At least one driver with self-powered DALI link
1
9.5–20.5 V-
80-250 mA
041600
Rev. A
03/2017
*
For set-up, programming, and
troubleshooting with a Vive system,
please refer to the installation
instructions included with the Vive hub
or at www.lutron.com
Clear Connect Wireless Fixture Controllers
UL2043PlenumRated
Controlsupto4ballastsordrivers(IEC60929AnnexE.2requireseachballastor
drivertolimitthesink/sourcecurrentdrawto2.0mAmaximum).
DefaultFunctionality
Fixture Controls
Auto On level: DFCSJ-OEM-OCC only
(notapplicableforDFCSJ-OEM-VAC orDFCSJ-OEM-RF)
Varieswithambientlightlevelwhenoccupancyistriggered
(e.g.,100%foradarkroom,10%forabrightroom).
Timeout period:15minutes
Connector buttons
0.04in(1mm)
or less
0.041to0.08in
(1.1to2mm)
0.081to0.13in
(2.1to3.3mm)
DaylightingSensor
Donotinstallindirectviewofthelightsourceorreflectingsurface.
PIRSensor
• Installinalocationthatallowsthesensortohaveanunobstructedviewofthearea.
• Installawayfromradiatedheatgivenoffbythelightsource.
Temperature
Thewirelessfixturecontrolisratedfor55°C(131°F)maximum.Productmustbeinstalledinanarea
thatwillnotallowittoexceedthisrating.Keepawayfromheatgeneratingdevices(e.g.,drivers)and
verifyduringthefixturedesignprocess.
WiringBestPractices(forRFconsideration)
• Keepallthefixturewiringtotheminimumlengthneededtoachievetheconnectionsinanorganizedmanner.Avoidunnecessaryslackinthe
wires.
• Ifthedriverisprovidedwithagroundterminal,thisterminalmustbeelectricallyconnectedtothegroundedfixturemetalusingagroundwire
thatisnolongerthan2in(51mm).
• Mechanically affix all the wires to the fixture wall so that they are kept as close possible to the grounded fixture metal.
• Ensurethatthedriverwiringisasfaraspossiblefromthewiringimmediatelyconnectedtothewirelessfixturecontrol
• EnsurethatthewirelessfixturecontrolismountedawayfromtheLEDstripstominimizethecouplingoftheRFradiationfromtheLEDstrips
into the wireless fixture control.
• Formoreinformation,seewww.lutron.com/TechnicalDocumentLibrary/048620.pdf
Wirelessfixturecontroller(RFonly)
•
TheWirelessfixturecontroller(RFonly)(DFCSJ-OEM-RF)canbeinstalledonthebackofthefixture,assumingmetaltilesarenotbeingused.
• TheWirelessfixturecontroller(RFonly)willberatedforuseinplenumareas.
• Donotfullyenclosewithinthemetalfixture.
MountingtoCurvedSurfaces
Mountingdirectlytoacurvedsurfaceisnotrecommended.Anadaptor(custommanufacturedbytheOEM)mayberequiredtoensurethat
thedeviceisseatedproperly.
Remote Mounting
The wireless fixture control is intended for troffer and linear fixtures and is not intended to be ceiling mounted.


WiringDiagrams
120–277V~
120–277V~
Wireless sensor interface
EcoSystem/DALIdriver
Driverwithself-poweredDALIlink
EcoSystemdriver
Driverwithself-poweredDALIlink
Clear Connect Wireless
Fixture Controller
Clear Connect Wireless
Fixture Controller
Button
Button
PIRlens
Daylight
sensor lens
Daylight
sensor lens
OR
FCC information and IC information
Thisdevicecomplieswithpart15oftheFCCRulesandIndustryCanada
license-exemptRSSstandard(s).Operationissubjecttothefollowing
twoconditions:(1)Thisdevicemaynotcauseinterference,and(2)this
devicemustacceptanyinterference,includinginterferencethatmay
causeundesiredoperation.Modicationsnotexpresslyapprovedby
LutronElectronicsCo.,Inc.couldvoidtheuser’sauthoritytooperatethis
equipment.
NOTE: This equipment has been tested and found to comply with the
limitsforaClassBdigitaldevice,pursuanttopart15oftheFCCRules.
Theselimitsaredesignedtoprovidereasonableprotectionagainst
harmfulinterferenceinaresidentialinstallation.Thisequipmentgenerates,
usesandcanradiateradiofrequencyenergyand,ifnotinstalledandused
inaccordancewiththeinstructions,maycauseharmfulinterferenceto
radiocommunications.However,thereisnoguaranteethatinterference
willnotoccurinaparticularinstallation.Ifthisequipmentdoescause
harmfulinterferencetoradioortelevisionreception,whichcanbe
determinedbyturningtheequipmentoffandon,theuserisencouraged
to try to correct the interference by one or more of the following
measures:
• Re-orientorrelocatethereceivingantenna.
• Increasetheseparationbetweentheequipmentandreceiver.
• Connecttheequipmentintoanoutletonacircuitdifferentfromthatto
whichthereceiverisconnected.
Clear Connect Wireless Fixture Controllers with
Ecosystem or DALI Driver
Wireless Fixture Control with Driver with
Self-powered DALI Link
N
L
S+
S-
E+
E1
E-
E2
Wireless sensor interface
120–277V~