User's Manual

®
For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye® QS Control Unit Quick Installation and Operation Guide 11
Wireless Mode
Many models of the GRAFIK Eye® QS control unit support wireless communication
with other Lutron products. This feature allows for easy integration of wireless sensors,
keypads, remotes, and shades for single-room wireless applications, as well as
compatibility with other Lutron wireless systems such as RadioRA® 2.
(See the RadioRA®SetupGuide;LutronPN044254.)
Units supporting wireless communication are labeled “GRAFIK Eye® QS Wireless” on
the front label of the unit.
The wireless feature of the GRAFIK Eye® QS Wireless control unit has three (3) modes
of operation.
• Disabled: Use for wired-only systems.
• Enabled: The GRAFIK Eye
® QS Wireless control unit will respond to any programming
commands from nearby Lutron QS wireless (and compatible) products.
• Ignore Programming (default): The GRAFIK Eye
® QS Wireless control unit will only
respond to normal operation commands from wireless devices associated while in
Enabled mode.
Changing the wireless mode of the GRAFIK Eye® QS Wireless control unit:
1. Enter programming mode.
2. Use the Master buttons to highlight “Wireless Mode” and press
the OK button to accept.
3. Use the Master buttons to highlight the desired wireless mode,
and press the OK button to accept.
4. The info screen will display a confirming “Saved” message.
5. Exit programming mode.
Notes
•
The wireless signal has a range of 30 ft (9 m) through standard
construction or 60 ft (18 m) line of sight.
• WhenusedwithinaRadioRA® 2 system, the wired QS link on the
GRAFIK Eye® QS control unit is disabled, and certain features
that do not pertain to RadioRA® 2 are not accessible.
Wireless Mode
Enabled
Saved
Saved
Main menu
Shade labels
Wireless Mode
FCC Information
Changes or modifications not expressly approved
by Lutron Electronics Co. could void the user’s
authority to operate this equipment.
Note: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
rules and Industry Canada license-exempt RSS
standard(s) . Operation is subject to the
following: (1) This device may not cause harmful
interference, and (2) this device must accept
any interference received, including interference
that may cause undesired operation.
These limits are designed to provide
reasonable protection against harmful interference
in
a residential and commercial installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio or television
reception. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
•
Reorient
orrelocatethereceivingantenna.
•
Increase
theseparationbetweentheequipment
and receiver.
•
Connect
theequipmentintoanoutletona
circuit different from that to which the receiver is
connected.
•
Consult
thedealeroranexperiencedradio/TV
technician for help.
OK
Master
buttons
OK
button
Timeclock
(back) button