User's Manual

Permanent Installation
1. Note: Anchor usage is optional. Skip to the next step if not using anchors.
1.1. Drill two 3/16-inch holes for the provided anchors using the mounting bracket as
a template. The anchor holes should be across from each other.
Anchor
Locations
Anchor
Locations
1.2. Install anchors.
2. Place mounting bracket flush against the wall with the smooth side against the wall
and install the two provided screws using a hand screwdriver.
NOTICE: Use of a hand screwdriver is recommended.
NOTICE: Use of a power screwdriver is NOT recommended
3. Attach the Sensor to the mounting bracket by twisting in a clockwise direction until
the Sensor and mounting bracket are attached.
7 of 7