User's Manual

Motion Sensor Coverage Testing
1. Remove sensor from wall-mounting bracket.
2. Press test mode.
3. Replace wall-mounting bracket.
4. Adhere unit to ceiling.
5. Confirm the coverage area by walking in the Sensor space and observe the Lens LED
state. The Lens LED in the on state signifies motion detected and the Lens LED in the
off state signifies motion not detected.
6. Tweak the sensor coverage area by temporarily mounting in a different location if
necessary and repeat this step as necessary.
7. Remove the sensor from Test Sensitivity Mode by pressing the Test button. Test LED
will turn off. Note: Test Sensitivity Mode automatically exits 5 minutes after entering
the mode.
8. Remove and discard “Temporary Mounting Material”.
6 of 7