User's Manual

System Setup
1. Turn on the Dimmer.
2. Remove mounting plate. Have sensor in hand.
3. Press and hold the Dimmer’s tap button during this entire step. The LEDs blink one at
a time, from the bottom up to the top. After approximately 8 seconds, the LEDs will
start to cycle slowly from top to bottom (setup mode). Continue to hold the tap button
and go to step 4.
4. While observing the dimmer, press and hold the Sensor Add button until the
dimmer’s LEDs chase from top to bottom. As the Dimmer learns the Sensor, the
LEDs on the Dimmer will cycle quickly from top to bottom. Release the Dimmer tap
button to exit set-up mode, and then release the Sensor Add button.
Sensor Placement
1. Find a suitable location to mount the sensor, taking into account the Sensor RF
Coverage area and the Motion Floor Coverage area. Sensors must be within 30 feet of
the receiving RF devices. Motion Floor Coverage is line of sight.
4 of 7