User's Manual

Important Notes
1. Use only high quality lithium batteries, size CR123, 3V. Do not use rechargeable
batteries. Using improperly rated batteries could damage the sensor.
2. Clean control with a soft damp cloth only. Do not use any chemical cleaners.
3. The sensor is intended for indoor use only. Operate in ambient temperatures between
0 °C (32 °F) and 40 °C (104 °F) and 0-99% relative humidity condensing.
4. Do not paint controls.
5. The range and performance of the RF System is highly dependent on a variety of
complex factors such as:
• Distance between system components
• Geometry of the home
• Construction of walls separating system components
• Electrical equipment located near system components
6. The range and performance of the Motion Sensor is highly dependent on line of sight.
The occupant sensor must have an unobstructed view of the room. Do not mount
behind or near tall cabinets, shelves, hanging fixtures, etc.
FCC Information
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by Lutron Electronics Co.
could void the user’s authority to operate this equipment.
Operation is subject to the following: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may
cause undesired operation.
Included Parts
1. One Sensor
2. Two Batteries
3. One Mounting Bracket
4. Two screws
5. Two Anchors
6. Temporary Mounting Material (putty or sticky tape)
7. Installation Sheet
2 of 7