User's Manual

Mounting Diagram
Wallbox
Wallplate
Adapter*
Wallplate*
Keypad
Mounting
Screws
Keypad
Adapter
Mounting
Screws
2
* Wallplate and Adapter are purchased separately.
1. Turn power OFF at fusebox or circuit breaker.
2. Prepare wires. When making wire connections, fol-
low the recommended strip lengths and combina-
tions for the supplied wire connectors. Note: Wire
connectors provided are suitable for copper wire
only.
Small:
Strip insulation .375" (10mm) for
14AWG (2.5mm
2
).
Strip insulation .5" (13mm) for 16AWG
(2.5mm
2
).
Use to join one 14AWG supply wire
with one 16 or 18AWG (1.0mm
2
) con-
trol wire.
3. Wiring: See Wiring Diagram (page 3)
4. Push all wires back into the wallbox and loosely fasten
the control to the wallbox using the screws provided.
Do not pinch the wires.
5. Attach Lutron Claro® or Satin ColorsTM
wallplate
adapter and wallplate.
a. Loosely install keypad mounting screws.
b. Tighten adapter mounting screws snug.
c. Tighten keypad mounting screws until keypad
is flush to wall (do not over-tighten).
d. Snap wallplate onto adapter.
6. Restore power.
Included:
Wire Connectors (3)
Mounting Screws (2)
Installation
Danger - Locate and remove fuse or lock circuit
breaker in the OFF position before proceeding.
Wiring with power ON may result in personal
injury.
Small