User's Manual

Preliminary RadioRA Car Visor Instructions 09/19/01
Page 5 of 10
Step 3 Assign a Dimmer,
Switch, or GRAFIK Eye Control
Unit to the button.
Notes:
• Multiple Dimmers, Switches, or GRAFIK
Eye ® Control Units can be assigned to a
button.
• Controls must be assigned to a Car Visor
Control button while its LED is flashing.
Assign Dimmers or Switches to the Car
Visor Control button by turning the Controls
ON.
Assign a GRAFIK Eye ® Control Unit to the
Car Visor Control button by changing the
selected GRAFIK Eye ® scene.
If you assign the wrong Dimmer, Switch, or
GRAFIK Eye ® Control Unit to the Car Visor
Control button, turn the Dimmer, Switch, or
GRAFIK Eye ® Control Unit OFF to unassign
it.
Note: GRAFIK Eye ® Control Units will
automatically turn on to scene 1 once
assigned.
Step 4 Select a Button
2-3 until all buttons are programmed. When
finished, proceed to Step 5.
Step 5 Complete assigning
Dimmers, Switches, or GRAFIK
Eye® Control Units to buttons
Simultaneously press and hold the 2nd and
4th buttons in the right most column until all
LEDs begin to flutter (approximately 3
seconds).