User Manual

Aer praccing the previous procedures, you can aempt to follow the below flying paerns.
a. Revolve the helicopter around a fixed point.
b. Go forward and turn le unl you complete a rectangle.
c. Landing at a fixed point.
d. Fly in a figure 8 paern.
8. Pracce Flight
1. If the baery of the controller is low, the flying distance will shorten and the helicopter will have
limited elevaon and will maneuver slowly.
2. In case the helicopter will not be used for a long period of me, please remove the baery from the
remote control to prevent damage.
3. In case the helicopter suffers damage or alteraons, go to a local technician. If the propeller shows
signs of wear or damage avoid flying. A damaged propeller may cause accidents.
4. Before flying, always press the “ON” buon on the remote control before turning the helicopter’s
power switch “ON”.
5. Aer flying, turn “OFF” the switch on the remote control, then turn “OFF” the switch on the
helicopter.
9. Precauons
1. Clean the helicopter with a clean and slightly damped cloth.
2. Do not expose to direct sunlight or excessive heat.
3. Do not submerge equipment in water.
4. Turn the power “OFF” on the remote control and helicopter when not un use.
5. Remove the baeries from the remote control if storing the unit for a long period of me.
6. Use brand new alkaline baeries for best results.
7. Check the equipment regularly for damage or loose parts that may cause injury.
10. Maintenance
a b
c
d
・The power may be in the “OFF”posion .
・Baeries may be installed incorrectly.
・Baeries may be drained.
・Push the power buon to “ON”.
・Check that baeries are correctly installed.
・Recharge or replace baeries.
The remote control
is not responding.
PROBLEM CAUSE SOLUTION
・The power switch may be in the “OFF” posion.
・The antenna is damaged.
・There are strong winds prevenng controllable
movement.
・ The unit is not synced with the remote control.
・Turn the power switch to “ON”.
・Double check that the antenna is visible
and aached.
・Do not fly under strong currents of wind.
・Descend the helicopter and replace
baeries and /or resynchronize the
control with the unit.
The helicopter is
not responding.
・The propeller is turning too slowly.
・The baery on the helicopter has drained.
・Press the Throle sck forward further.
・Recharge the internal baery on the
helicopter unit.
Helicopter will not
elevate or fly
properly.
・The throle sck on the controller descended
suddenly.
・When landing, lower the throle sck
on the controller very gently.
Forced landing.