PLEASE READ ALL OPERATING INSTRUCTIONS BEFORE USING
1. Introduction Please keep this instruction manual for future reference. 1. Specifications: ・ Length: 9.2” ・ Width: 2.25” ・ Height: 4.23” 2. Electrical Specifications: ・ Helicopter: 1 lithium battery 3,7 volts 200 mAh ・ Remote Control: 4 batteries of 1,5 Vcc AA (Not Included) 3. This product has high stability due to advanced gyroscope technology. ・ We recommend fully charging the battery before first flight. 2.
. Safety Precautions 1. Read the instructions carefully before operating. Please follow these instructions when using your equipment. 2. Keep small parts away from young children to avoid risk of suffocation. 3. Do not expose batteries to heat or fire. 4. Position yourself five to ten feet away from the helicopter in flight. Make sure the helicopter does not come in contact with the face, head or body of any person or animal. 5. Do not modify the product without supervision, damage may be beyond repair. 6.
5. Charging the Battery (Helicopter) To charge the battery of the helicopter: 1. Turn the switch on the helicopter “ON” 2. Connect the battery charger. While the helicopter is charging, make sure that the switch is in the ON position Caution: 1. Make sure the charger is connected to the outlet. 2. The battery can be damaged by overheating or over charging, please disconnect if the charger is overheating. 3. The charger has an advanced and specific functioning system. For safety do not use other chargers.
7. Flight Control To learn how to maneuver the helicopter, start with the basics. Difficult maneuvers are the combination of simpler maneuvers. Step 1 - Horizontal Flight: Push the throttle stick forward to lift the helicopter off the ground, pull it gently until it lands. Do not make sudden movements. Continue to practice lift-off to higher altitudes until you are comfortable with the controls. Step 2 - Directional Flight: Raise the flying height of your helicopter around five feet.
8. Practice Flight After practicing the previous procedures, you can attempt to follow the below flying patterns. a. Revolve the helicopter around a fixed point. b. Go forward and turn left until you complete a rectangle. c. Landing at a fixed point. d. Fly in a figure 8 pattern. a b PROBLEM CAUSE c d SOLUTION The remote control is not responding. ・The power may be in the “OFF”position . ・Batteries may be installed incorrectly. ・Batteries may be drained. ・Push the power button to “ON”.
11. How to edit the flashing characters and download the Software 1. Plug the MiniUSB cable into the helicopter and computer. 2. Insert the Heligram CD in the computer’s disk drive. 3. Open the CD, double click on Lutema You can Copy the Software folder from the CD to the computer. Double click on Lutema so you can edit the flashing text from your computer without runing the software from the CD. Computer - Helicopter Connection Status 12. Software Procedure 2. Choose the opening and closing mode.
