Installation Instructions

PAGE 16 of 20
Installation Steps
PAGE 5 of 20
10
1703138
Rev.1
Engage rear rail to latch assembly and rotate down as shown.
If the cover is too tight, loosen the adjusting bolts evenly on both sides towards the -
If the cover is too loose, tighten the adjusting bolts evenly on both sides towards the +
Note: Proper cover tension is achieved when the rear rail requires moderate pressure to
fully latch.
A
Release the buckles and unroll the cover.
9
To access the truck bed, pull both release cables and roll cover forward.
Fasten buckle straps to stow cover.
B C
B
C
A
g
n
i
v
Adjusting tension increases or decreases the
tailgate seal engagement.
Proper tensioning shown above
Tailgate
Seal
Engagement
Release Cable
Original Adjustment from factory
Decrease Cover
Tension (-)
Do not loosen
past this point
Increase tailgate seal
engagement as much
as 1/8”
decrease tailgate seal
engagement as much
as 1/8” total
decrease tailgate seal
engagement as much
as 1/4” total
decrease tailgate
seal engagement as
much as 3/8” total
Do not tighten
past this point
Increase Cover
Tension (+)
A
D
E
B
A
D
E
C
=
8
1703138
Rev.1
Étapes d'installation
Installer les écrous à embase comme illustré.
Positionner le rail avant, de façon à ce que ses deux
extrémités présentent le même jeu.
Serrer les deux écrous à embase.