Installation Instructions

Installation Steps
PAGE 2 of 6
1
2
3
4
Remove the white backing from the foam on the front and side rails. It will be necessary to release the
buckles on the front rail to do this but do not unroll the cover. Re-fasten the buckles once the foam backing is removed.
With the tailgate closed, lay the ends of the driver side rail on the truck bed bulkhead and tailgate.
The
latches are positioned toward the rear and the foamed side of the rail faces the inner side wall of the truck bed.
Loosen all clamp bolts as far as possible without
allowing
the assemblies to completely seperate.
1
2
3
B
F
B
F
The upper tip of the outer clamp needs to be located up
into
the side rail and rotated out until the outer clamp and
the
side rail mate together as shown.
B
F
The rear clamp needs to be positioned as far
back
as possible while the front clamp needs to
positioned
as far forward as possible. the middle
clamp
should be centered as best as the truck
bed
will allow. Proceed to step 5 and install the
rear
clamp first, the front clamp second and the
middle
clamp last.
B
Inner
Clamp
Outer
Clamp
F
F
F
1
3
2
1703118
Rev.2