Installation Instructions

ManualsBrandsLund ManualsAutomotiveGenesis Roll Up Tonneau 2004-2007 Chevrolet/GMC Silverado/Sierra 5.5' Box

Contents

For proper installation and best possible fit, please read all instructions BEFORE you begin.

For technical assistance or to obtain missing parts, please call Customer Service at 1-800-328-5863.

Tools Required

Important

Preparation Before Installation

PAGE 1 of 6

WARNING/CAUTION/NOTE

Please read this manual and follow its instructions carefully. To emphasize special information,

the

symbol and the words WARNING, CAUTION and NOTE have special meanings. These

special

meanings apply excerpt when laws or regulations require that the signal words be used

with

a different meaning.

7/16"

7/16”

Combination

Wrench

7/16”

Socket

Genesis Roll Up Tonneau Cover

Cover Assembly

Driver Side Rail

Passenger Side Rail

Clamp Assembly

Carriage Bolt

Flange Nut

• Wash the upper rail surfaces of the truck bed.

• Be sure to completely dry the upper surfaces of your truck bed before

ins

talling your rails.

1703118

v.2

Summary of content (6 pages)

PAGE 1
703118 Rev.2 Installation Instructions Genesis Roll Up Tonneau Cover For proper installation and best possible fit, please read all instructions BEFORE you begin. For technical assistance or to obtain missing parts, please call Customer Service at 1-800-328-5863.
PAGE 2
1703118 Rev.2 Installation Steps B 1 Remove the white backing from the foam on the front and side rails. It will be necessary to release the buckles on the front rail to do this but do not unroll the cover. Re-fasten the buckles once the foam backing is removed. With the tailgate closed, lay the ends of the driver side rail on the truck bed bulkhead and tailgate. The latches are positioned toward the rear and the foamed side of the rail faces the inner side wall of the truck bed.
PAGE 3
1703118 Rev.2 Installation Steps C B F Position each inner clamp as shown and tighten the two bolts on each clamp. 5 Note: Repeat steps 1-5 for Passenger Side Rail. If C 6 Open the tailgate and make sure the driver and passenger side rails are horizontal as shown. If they are not, proceed to step 7, otherwise proceed to step 8. Then B F F Re-position all inner clamps downward. A F D Then If C B F Re-position all inner clamps upward.
PAGE 4
1703118 Rev.2 Installation Steps D A B E = A D E C 10 PAGE 4 of 6 Loosely install the flange nuts as shown. Position the front rail so the gaps at each end of the front rail are equal. Tighten both flange nuts.
PAGE 5
1703118 Rev.2 Installation Steps A 11 Release the buckles and unroll the cover. B A C A v in g B C Release Cable Engage rear rail to latch assembly and rotate down as shown. If the cover is too tight, loosen the adjusting bolts evenly on both sides towards the - towards the If the cover is too loose, tighten the adjusting bolts evenly on both sides + Note: Proper cover tension is achieved when the rear rail requires moderate pressure to fully latch.
PAGE 6
1703118 Rev.2 Inspection After Installation 1. After installation is complete, confirm proper operation. Care and Cleaning 1. Wash only with mild soap & dry with a clean cloth. 2. Avoid the use of automatic “brush - style” car washes. 3. Do not use cleaning solvents of any kind. 4. Periodically check the cover tension and all components for tightness. Refer to step 12 for cover tension adjustment. 5. Do not use release cables as handles. 6. Do not pull on release cables to enter truck bed. 7.