Owners manual

PAGE 19 of 20
NOTES
1703138
Rev.1
Installation Steps
PAGE 2 of 20
1
3
4
2
Remove the white backing from the foam on the front and side rails. It will be necessary to release the
buckles on the front rail to do this but do not unroll the cover. Re-fasten the buckles once the foam backing is removed.
With the tailgate closed, lay the ends of the driver side rail on the truck bed bulkhead and tailgate.
The latches are positioned toward the rear and the foamed side of the rail faces the inner side wall of the truck bed.
Remove clamp bolts and seperate clamps as
shown.
B
F
F
Rotate each inner clamp into position as shown, then
install each outer clamp and hardware. The outer clamps
mate with the side rails as shown in the sectional view.
B
F
The rear clamp needs to be positioned as far
back as possible while the front clamp needs to
positioned as far forward as possible. The middle
clamp should be centered as best as the truck
bed will allow. Proceed to step 3 and install the
rear clamp first, the front clamp second and the
middle clamp last.
B
Inner
Clamp
Outer
Clamp
F
F
F
1
3
2
1703138
Rev.1
B
Optional Utility
Track System
Shown
NOTE: Clamps will work with
and without the optional Utility
Track System.