Owners manual

PAGE 17 of 20
6
1703141
Rev.1
Avertissement : Les blessures et les dégats matériels sérieux peuvent se pro-
duire si le véhicule est conduit sans les deux boucles noires à l'avant de la cou-
verture attaché.
7
A
En arrimant la couverture, placez
toutes les brides en leur position
de stockage ou la poignée peut
perforer la couverture et la
garantie vide.
A
A
Dévoilez en second lieu, puis troisièmement des sections de la couverture. Pour des étapes
d'installation de bride, référez-vous à l'étape 5.
A
Étapes d'installation
PAGE 4 of 20
Installation Steps
5
1703141
Rev.1
A
Warning: Prior to vehicle operation, clamps must be secured such that the
clamps’ lips tightly grip the inner bedwall structure.
Vehicles Equipped With Cargo Management System
Slide clamps to edge of truck bed.
Rotate clamps down from its storage
position.
Adjust clamps to proper height.
Rotate clamps to locking position.
Repeat for opposite side.
Note: Repeat steps for rear
clamps.
A
A
A
•Tighten
•Loosen
A
A
A
Slide clamps to edge of truck bed.
Rotate clamps down from its storage
position.
Adjust clamps to proper height.
•Tighten
•Loosen
Rotate clamps to locking position.
Repeat for opposite side.
Note: Repeat steps for rear
clamps.
Vehicles NOT Equipped With Cargo Management System
Note: Clamp must be installed to fit the
center of the adaptor assembly (Item C)
as shown. If clamp is not centered as
shown, refer to step 1 and reposition
accordingly.
A
C