User's Guide

EN
2. Make sure the remote and helmet are
close to each other. Touching is best.
3. Hold both buttons on the Remote Lite
until the remotes light starts ashing.
4. Wait for 1-2 seconds before activating
the L button on the remote. You should
now see the turn signal on the helmet
turning on.
5. If it doesn’t activate the helmet, try steps
1-3 again, and then activate the R button
on the remote.
Pairing Helmet With App
To get the most out of the helmet, you can
download the Lumos Companion app on
the App Store for iPhones or the Google
Play Store for Android phones. After you
have downloaded the app, you will have to
pair the helmet with your phone. Simply:
1. Turn on the helmet in pairing mode
(when the helmet is off, hold the power
button until the helmet blinks orange rear
lights).
Note: make sure you’ll be holding the power
button long enough to enter pairing mode,
if you press it too short the helmet will just
turn on in normal mode.
2. Open the Lumos Companion app and
turn on Bluetooth on your phone.
3. Go to Help Center > Pair” with a
new helmet. On Android, this starts
automatically.
Pairing With Apple Watch
If you have an Apple Watch, you may install
our Lumos Companion app for the Apple
Watch. This will allow you to activate the
turn signals on the helmet with your hand
signals done via your Watch hand.
To Install (Before you start, please make
sure you’re on the most updated version of
Watch OS.):
1. Click on the Watch icon on your phone.
2. Scroll down to “Available Apps” > Click
Install
Once you installed the app on your Watch,
you’ll need to calibrate it to your helmet.
Simply follow the steps on your Watch to
calibrate.
Automatic Brake Lights
The helmet comes with Lumos Remote
Lite. In order to activate automatic brake
lights, please purchase the Lumos Remote
and follow the instructions from the
packaging
Buckling / Unbuckling Fidlock
To lock, slide the buckle with the dlock
logo laterally. It should automatically snap.
To unlock, slide laterally away. It should
snap off.
Cleaning Your Visor
Use a microbre or soft cloth with
lukewarm soapy water to clean the visor.
Do not scrub heavily as it is very easy to
damage / scratch the visor. Be gentle.
Warm water is cheaper than a new visor.
Note: Do not try and remove the visor from
the helmet. The visor is non-detachable and
you might risk damaging the electronics of
the helmet. This might void your warranty.