User's Guide

EN
www.lumoshelmet.co
support@lumoshelmet.co
Company Information:
Lumos Labs International
Pte Ltd. 11,
Collyer Quay,
#17-00, The Arcade,
Singapore 049317
Distributor for Australia:
C.R. Kennedy &
Company Pty. Ltd.
300 Lorimer St,
Port Melbourne VIC 3207,
Australia.
Specic Statement - Canada
This device complies with Industry
Canada license-exempt RSS standard(s).
Operation is subject to the following two
conditions:
(1) This device may not cause
interference, and (2) This device must
accept any interference, including
interference that may cause undesired
operation of the device.
Usage Warnings
Warning: No helmet can protect the wearer
against all possible impacts.
Warning: This helmet can only protect if it
ts well and that the buyer should try dif-
ferent sizes and choose the size which feel
secure and comfortable on the head.
Warning: The helmet is designed to be
retained by a strap under a lower jaw. The
straps positioned so that they do not cover
the ears, the buckle positioned away from
the jawbone and the straps and buckle
adjusted to be both comfortable and rm.
Warning: To be effective, a helmet must t
and be worn correctly. To check for correct
t, place helmet on head and make any
adjustments indicated. Securely fasten
retention system. Grab the helmet and try
to rotate it to the front and rear. A correctly
tted helmet should be comfortable and
should not move forward to obscure vision
or rearward to expose the forehead.
Warning: No attachments should be made
to the helmet except those recommended
by the helmet manufacturer.
Warning: The helmet is designed to absorb
shock by partial destruction of the shell and
liner. This damage may not be visible. There-
fore, if subjected to a severe blow, the helmet
should be destroyed and replaced even if it
appears undamaged.
Warning: The helmet may be damaged
or rendered ineffective by petroleum and
petroleum products, cleaning agents, paints,
adhesives and the like, without the damage
being visible to the user.
Warning: A helmet has a limited lifespan in
use and should be replaced when it shows
obvious signs of wear.
Warning: When you need to let the helmet
dry, do so with the open side downwards on
a at surface.
Warning: This helmet should not be used
by children while climbing or doing other
activities where there is a risk of hanging or
strangulation if the child gets trapped whilst
wearing the helmet.
Warning: No attachments should be made
to the helmet except those recommended
by the helmet manufacturer.
Warning: To clean, wipe with a soft, damp
cloth and mild soap only.
Warning: Take the helmet and other Lumos
devices inside after a ride and store in a dry
place at room temperature.
Warning: Do not rinse the devices nor take
your helmet to the shower to give it a wash.
Warning: Use a microbre or soft cloth with
lukewarm soapy water to clean the visor.
Do not scrub heavily as it is very easy to
damage / scratch the visor. Be gentle.
Warning: Do not try and remove the visor
from the helmet. The visor is non-detachable
and you might risk damaging the electronics
of the helmet. This might void your warranty.
RF Warning - Statement
The device has been evaluated to meet
general RF exposure requirement. The
device can be used in portable exposure
condition without restriction.