USER GUIDE MANUAL GUIDE DE L'UTILISATEUR BENUTZERHANDBUCH
If there are variations between different languages, the English version will prevail. Lumos Ultra E-Bike Helmet User Guide Before using your Lumos Ultra E-Bike Helmet, review the user guide at: lumoshelmet.co/ultraebike Safety and Handling See “Fitting instructions and usage warnings” in the Lumos Ultra E-Bike Helmet User Guide Manual. Fitting Instructions The helmet must fit properly to be effective. With a proper fit, the helmet will not move back and forth or side to side while fastened.
product. This limited warranty does not cover normal wear and tear. This limited warranty does not apply to anything other than defects in the manufacturing and workmanship of the product.The limited warranty is waived if you seek to repair the product using anything other than approved Lumos products and services, or if you seek to combine the product with any third party product (like sealants, cameras, or custom helmet pads).
RF Warning - Statement The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. Specific Statement - Canada This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
Fitting Guide The correct position on your head 1. Loosen off the retention system and place the helmet on your head. 2. The correct position of the helmet is just out of your eyeline, not touching your eyebrows. Make sure the helmet is not leaning forward too much, as it can block your sight. The helmet should also not sit too much backwards, because then it will not protect against frontal impacts. 3. Tighten up the retention system by turning the adjustment knob on the back until the helmet feels snug.
2. Make sure the remote and helmet are close to each other. Touching is best. 3. Hold both buttons on the Remote Lite until the remote’s light starts flashing. 4. Wait for 1-2 seconds before activating the L button on the remote. You should now see the turn signal on the helmet turning on. 5. If it doesn’t activate the helmet, try steps 1-3 again, and then activate the R button on the remote.
FCC Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
