Quick Read Technology Automatic Wrist Blood Pressure Monitor Model 1143 GF Health Products, Inc.
Two Year Limited Warranty GF Health Products, Inc. guarantees this product free from defects in material and workmanship for a period of two years from the date of purchase, except as noted below. Table of Contents Introduction ..................................................................... 3 About Blood Pressure ................................................ 4, 5 Parts Identification .......................................................... 6 Display Symbols & Explanations........................
Introduction Congratulations on your purchase of the new Lumiscope Model 1143. This automatic wrist blood pressure monitor is both easy-to-use and ideally suited for daily measurements. The large display includes systolic blood pressure reading, diastolic blood pressure reading and the pulse rate, all clearly shown at the completion of each reading. You can store up to 85 measurements, ideal for users who want to monitor and track their blood pressure on a regular basis.
Troubleshooting Message Correction The pressure measured was lower than 20 mmHg. Solution: Please measure again. The pressure measured was higher than 300 mmHg. Solution: Please measure again. Pumping error. Solution: Please check cuff and try again. The pressure can not be measured due to signal noise. Solution: Please measure again. About Blood Pressure What is Blood Pressure? Blood pressure is the pressure exerted on the artery tube while blood flows through the arteries.
Care & Maintenance About Blood Pressure Blood Pressure Standard The World Health Organization (WHO) and National High Blood Pressure Education Program Coordinating Committee have developed a blood pressure standard, according to which areas of low- and high-risk blood pressure are identified. This standard, however, is a general guideline and blood pressures vary between different people, age groups, etc. It is important that you consult with your physician regularly.
Clock Settings Parts Identification Setting the Clock, Date & Time A. Press and hold the “MEMORY” button for over 3 seconds. The display will show a blinking year. Press the “START/ . STOP” button to adjust the year when it’s blinking. / B. Press the “MEMORY” button again. The “MONTH” will appear and blink to be adjusted, the “DATE”, “HOUR” and “MINUTE” will follow as you press and release the “MEMORY” button. C.
Display Symbols & Explanations Deleting the Memory To delete the memory Display Symbols 1. To delete one memory: A. Press the “MEMORY” button to display the record that you wish to delete. Systolic Pressure B. Press and hold the “START/STOP” button until the display shows “DEL”. Diastolic Pressure Pulse Rate Display Explanations Low Battery Indicator: Appears when the batteries are low or need replacement. C. Once the “DEL” has been displayed, press and hold the “START/STOP” button again.
Memory Recall To see the previously measured values A. Press the “MEMORY” button to recall the last reading. The LCD display will show the memory number, actual date and time simultaneously of the measurement. Installing the Batteries To insert the batteries A. Lift the cover towards you to open the battery compartment. Memory B. Insert 2 "AAA" batteries as indicated. Make sure to match polarities (+, –) on the batteries. Memory Number Date / Time C.
Correct Measuring Posture Measurement Procedures A. Place your elbow on a table so that the cuff is at the same level as your heart. (Fig. A.) C. Quick Read Technology detects your blood pressure with the touch of a button, which reduces measurement time significantly and decreases patient discomfort. Note: The level of your heart is slightly below your armpit. Fig. A Relax your entire body, especially the area between your elbow and fingers. B.
Measurement Procedures Applying the Cuff To start the measurement To apply the cuff Note: In order to get your correct measurement result and, to avoid erroneous measurements, you should be seated quietly. Your arm, hand, and fingers should be still during the measurement procedure. A. Remove all watches, jewelry, etc. prior to attaching the wrist monitor. Clothing sleeves should be rolled up and the cuff should be wrapped on bare skin for correct measurements. A. Press the “START/STOP” button.
Applying the Cuff Helpful Tips E. If it is not possible to measure on the left wrist, attach the cuff on the right wrist as shown in Fig. C Here are a few helpful tips to help you obtain a more accurate reading. A. Do not measure your blood pressure immediately after consuming a large meal. To obtain more accurate readings, please wait one hour before measuring. B. Do not smoke or drink alcohol before measuring your blood pressure. Fig. C C.
