Instruction Manual

4|Page
Replacement
The red REPLACE LAMP LED on the front of your unit will ash when the lamp
has started to decrease in UVC output (approx 1 year from install). This is a
warning to purchase a new lamp and replace as the UVC will decrease and you
will not obtain the same level of disinfection. When light turns solid, the lamp has
reached its end of life. Replacement Lamps are easily available from your local
retailer.
To replace your lamp:
1. Remove power cord from side of unit and allow lamp to cool for a few
minutes before proceeding.
2. With the palm of your hand push in and rotate the lamp holder
counterclockwise to lineup two arrows.
3. Carefully remove the lamp. CAUTION: Lamp may be hot.
4. Push lamp tabs in and pull the lamp out of the lamp holder (See instructions
below for discarding of lamp).
5. Attach the lamp to the lamp holder by steering the 4 pins into the four holes.
Push lamp tabs in and press the lamp into lamp holder See Fig 1. Ensure
lamp is locked into position.
6. Line up arrows on lamp holder & mounting plate and carefully insert lamp &
lamp holder into duct.
7. Once inserted, with the palm of your hand push and turn lamp holder
clockwise so that it locks into place.
8. Insert power cord into lamp holder and plug other end into outlet. A blue LED
will illuminate to show “power on”.
Your old UV Lamp(s) can be disposed of in the same manner you dispose of
uorescent lamps in your region.